|
Sipura SPA-2000 Setup
This hard phone is another ATA (analog telephone adaptor). It enables
you to connect your POTS (plain old telephone system) phones to the
Internet. Think of it as a phone jack for VoIP. It has one ethernet port
and two RJ11 phone jacks. This is one of the most feature rich and easy
to use ATA that we have tested. Out of the box, it is configured for
DHCP. This means that it gets its IP address from your DHCP server
automatically. Full documentation can be found at
Sipura's site.
NOTE: We have seen instances where installing the SPA-2000 behind a
firewall which blocks ICMP packets causes problems with registration.
Try turning off any ICMP blocking on your firewall.
STEP 1
You must first determine what IP address it received. To do this, you
need to pick up the phone attached to the Line 1 jack and dial:
**** (four asterisks)
then dial:
110 #
and you will be told the IP address of your device (e.g. 192.168.0.100)
STEP 2
Go to any browser equipped computer on your network and enter the
address: http://<IP ADDRESS>/
(where <IP ADDRESS> is replaced by the address that was given to you in
STEP 1.
STEP 3
Click on the "Admin Login" button near the top right side of the screen,
then click on the "Line 1" tab.
STEP 4
You need to modify only a few parameters from the factory default. They
are listed here:
| Proxy:
|
sip01br.cliconnect.com.br:5070 |
| OutBond Proxy:
|
alg01br.cliconnect.com.br:5070 |
| Display
Name: |
Enter your full name,
this will show up as part of your callerid. |
| User ID:
|
Enter the phone
number you chose when you signed up for Cliconnect service. |
| Password:
|
Enter the password
that you chose when you signed up for Cliconnect service.
|
STEP 5
Click on the "Submit All Changes" button at the bottom of the form.
STEP 6
Change the “Preferred Codec” to G723. Also change the “Use Pref Codec
Only” to No. You can do this for both Line 1 and Line 2 (i.e. if you
are going to use Line 2).
STEP 7
Make calls! |
