|
Grandstream HandyTone 286
This is an ATA adaptor with a single ethernet interface and one POTS
line enabling you to use a traditional phone or fax machine as a SIP
enabled IP device. This means that you will need an open ethernet port
on your local network. It is fairly simple to setup and almost identical
to the BudgeTone 100 configuration. The default configuration will get
an IP address via DHCP. The full manual can be found on
Grandstream's Website.
STEP 1
You must first determine what IP address it received. To do this, plug a
POTS phone into the RJ11 connector, lift the handset and press the red
button. Dial '02'. You will be told the IP address of your device (e.g.
192.168.0.100).
STEP 2
Go to any browser equipped computer on your network and enter the
address:
http://<IP ADDRESS>/
(where <IP ADDRESS> is replaced by the address that was given to you in
STEP 1.
STEP 3
You will be prompted to enter a password, the default is "admin", then
click the "Login" button.
STEP 4
You need to modify only a few parameters from the factory default. They
are listed here:
SIP Server: sip.cliconnect.com
SIP User ID: Enter the phone number you chose when you signed up
for Cliconnect service.
Authenticate ID: Enter the phone number you chose when you signed
up for Cliconnect service.
Authenticate Password: Enter the password that you chose when you
signed up for Cliconnect service.
Name: Enter your full name. This will show up as part of your
callerid.
SIP Registration: Yes
NAT Traversal: No
TFTP Server:
Change IP to 168.75.215.189
1. Set "Enable Call Feature" to "yes"
2. Then pick up the telephone that is connected to the HT486, upon
hearing the dial-tone press *92.
Send DTMF: via SIP INFO
STEP 5
Click on the "Update" button at the bottom of the form.
STEP 6
You will be brought to a confirmation screen on which you will click on
the only option available: "Click to view your changes".
STEP 7
Click on the "Reboot" button at the bottom of the form.
STEP 8
Start Calling. |
