|
Sipura SPA-3000 Setup
The SPA-3000 features VoIP adapter functionality found in the SPA-3000
with the additional benefit of an integral connection for legacy
telephone network “hop-on, hop-off” applications. SPA-3000 users will be
able to leverage their broadband phone service connections more than
ever by automatically routing local calls from cell phones and land
lines to a VoIP service provider and vice versa.
A typical user calling from a land line or mobile phone will be able to
reduce and even eliminate international and long distance telephone
charges by first calling their SPA-3000 via a local phone number or by
using a telephone connected directly to the unit. The advanced
authentication and call routing intelligence programmed into the
SPA-3000 will connect the caller via the Internet to the far end
destination with security and ease. Using the SPA-3000 at the far end,
calls can be answered immediately or further processed as a local call
to any legacy land line or mobile phone allowed by the SPA-3000 dial
plan.
If power is lost to the unit or the VoIP service is down, calls can be
sent to a traditional carrier via the FXO interface.
NOTE: We have seen instances where installing the SPA-3000 behind a
firewall which blocks ICMP packets causes problems with registration.
Try turning off any ICMP blocking on your firewall.
STEP 1
You must first determine what IP address it received. To do this, you
need to pick up the phone attached to the Line 1 jack and dial:
**** (four asterisks)
then dial: 110 #
and you will be told the IP address of your device (e.g. 192.168.0.100)
STEP 2
Go to any browser equipped computer on your network and enter the
address: http://<IP ADDRESS>/
(where <IP ADDRESS> is replaced by the address that was given to you in
STEP 1.
STEP 3
Click on the "Admin Login" button near the top right side of the screen,
then click on the "Line 1" tab.
STEP 4
You need to modify only a few parameters from the factory default. They
are listed here:
Proxy: sip.cliconnect.com
Display Name: Enter your Full name, this will show up as part of your
callerid.
User ID: Enter the phone number you chose when you signed up for
Cliconnect service.
Password: Enter the password that you chose when you signed up for
Cliconnect service.
STEP 5
Click on “PSTN Line” Tab.
Modify only the circled items of the following:
Proxy:
sip.cliconnect.com
Register Expires: 300
Display Name: Enter your full name.
Userid: Enter the phone number you chose when you signed up for
Cliconnect service.
Password: Enter the password that you chose when you signed up for
Cliconnect service.
STEP 6
Change the “Preferred Codec” to G729a. Also change the “Use Pref Codec
Only” to Yes. You can do this for both Line 1 and PSTN (i.e. if you are
going to use PSTN).
STEP 7
Click on the "Submit All Changes" button at the bottom of the form.
STEP 8
Start calling.
Note to Members: If you own a SPA 3000 and have questions, go to
http://www.sipura.com/support/spa3000faq/index.html |
