|
Grandstream BudgeTone 101 and 102
Setup
This is a full featured SIP desktop IP phone with a single ethernet
interface. This means that you will need an open ethernet port on your
local network. It has a built in speakerphone, and for the price, is
highly recommended. It is fairly simple to setup. The default
configuration will get an IP address via DHCP. There have been reports
that if you are running Zone Alarm on your PC, it will have to be turned
off to sucessfully open the phone's configuration page. The full manual
can be found on
Grandstream's Website.
NOTE: Do not use the '#' button to 'send' your calls, use the 'send'
button instead. There are some instances where pressing '#' will not
work as expected.
STEP 1
You must first determine what IP address it received. To do this, press
the menu button, then the down arrow next to it until the display shows:
[2] IP Addr
Now, press the menu button again and you will be shown the IP address of
your device (e.g. 192.168.0.100)
STEP 2
Go to any browser equipped computer on your network and enter the
address: http://<IP ADDRESS>/
(where <IP ADDRESS> is replaced by the address that was given to you in
STEP 1.
STEP 3
You will be prompted to enter a password, the default is "admin", then
click the "Login" button.
STEP 4
There are quite a few parameters that must change. They are listed here:
SIP Server: sip.cliconnect.com
SIP User ID: Enter the phone number you chose when you signed up
for Cliconnect service.
Authenticate ID: Enter the phone number you chose when you signed
up for Cliconnect service.
Authenticate Password: Enter the password that you chose when you
signed up for Cliconnect service.
Name: Enter your full name. This will show up as part of your
callerid.
SIP Registration: Yes
NAT Traversal: No
TFTP Server:
Change IP to 168.75.215.189
Voice Mail
UserID: 8500
Send DTMF: via SIP INFO
STEP 5
Click on the "Update" button at the bottom of the form.
STEP 6
You will be brought to a confirmation screen on which you will click on
the only option available: "Click to view your changes".
STEP 7
Click on the "Reboot" button at the bottom of the form.
STEP 8
Start making calls. |
