|
Cisco ATA 186/188 Setup
This hard phone is actually an Analog Telephone Adaptor. It enables you
to connect your Plain Old Telephone System phones to the Internet. It IS
as a phone jack for VoIP. It has one ethernet port and two RJ11 phone
jacks. It is fairly easy to configure. Out of the box, it is configured
for DHCP. This means that it gets its IP address from your DHCP server
automatically. Full documentation can be found at
Cisco's Site.
Since Cliconnect works only with SIP protocol, you need to make sure
that you are running the correct SIP firmware on your phone. The latest
version is 3.0 and can be found at
Cisco's Site.
STEP 1
You may first want to reset your unit to factory default setting. To do
this, pick up the phone handset attached to the Line 1 jack and press
the illuminated red button.
Dial: 322873738#
then dial * and hang up.
NOTE: this will completely reset the unit to factory default settings,
erasing any values that may already exist!
STEP 2
Now, again pick up the phone handset and press the red button, then
Dial: 21 #
and you will be told the IP address of your device (e.g. 192.168.0.100).
STEP 3
Go to any browser equipped computer on your network and enter the
address: http://<IP ADDRESS>/dev
(where <IP ADDRESS> is replaced by the address that was given to you in
STEP 1.
STEP 4
You need to modify only a few parameters from the factory default. They
are listed here:
UID0
|
Enter the phone number you chose
when you signed up for Cliconnect service. |
| PWD0 |
Enter the password that you chose
when you signed up for Cliconnect service. |
| GkOrProxy
|
sip.cliconnect.com |
| SIPRegInterval |
300 |
| SIPRegOn |
1 |
| DisplayName0
|
Enter your full name. This will
show up as part of your caller id. |
STEP 5
Click on the "apply" button on the bottom of the form.
STEP 6
Start making calls. |
